FSL1243WR

LINK LED BLANCO / AC / 122CM

El ventilador de techo Martec Link es un potente y eficiente ventilador de techo AC, con 4 palas de madera contrachapada. Dispone de un potente y eficiente motor AC de 55W de bajo ruido. Se complementa con un conjunto de 4 aspas que conformando un diámetro de 122cm. Su funcionamiento es sencillo, mediante mando a distancia.

599.00 €

| Blanco

+

1

-

Precio total: 150€

Mando a distancia de 5 -velocidades

Mando a distancia de 5 -velocidades

Tricolor CCT

Tricolor CCT

Reversible verano/invierno

Reversible verano/invierno

Anclaje seguro

Anclaje seguro

Plywood

Plywood

Motor AC

Motor AC

Características

keyboard_arrow_up
  • Motor AC con rodamiento de bolas de larga duración
  • Función verano/invierno
  • Dimmable
  • Mando a distancia de 5 velocidades con función de temporizador de hasta 8 horas (1h, 2h, 4h, 8h)
  • LED tricolor conmutable 3000K, 4000K o 5000K

Dimensiones

dimensions

Incluye

NADA

Instalación

Debe ser instalado por un profesional

Envío

Especificaciones

keyboard_arrow_up
NOMBRE LINK AC LED
REFERENCIA FSL1243WR
VELOCIDADES 5
MOTOR AC
MATERIAL Plywood
CAUDAL DE AIRE 9,800m3/h
CONTROLADOR Mando a distancia
MEDIDAS 1220mm
NÚMERO DE ASPAS 4
REVERSIBLE VERANO/INVIERNO
ANCLAJE SEGURO
TEMPERATURA 3000k/4000k/5000k
DIMMABLE Si
How Does Ripple Control Affect LED Lights?

A flickering LED light is the most common complaint arising from ripple control, which is generated when usually but not only when the light is dimmed and the ripple control frequency is in the line, usually between 300Hz and 1300Hz. The Flickr is often, but not always, intermittent depending on when the ripple control signals are being transmitted. It is normally at certain times i.e. 6 pm and then again at 8:30 pm and will only last for 30 seconds to 2 minutes, and when the power company stops sending the signal the flicker stops. People often notice it most acutely in the night when off-peak hot water systems are turned on. ALL brands of LED drivers are affected by these ripple control signals.

Why Doesn’t Martec have Ripple Control Filters in their LED Drivers?

Ripple control is not the norm and in many environments. While Martec does sympathise with the few customers who do experience a problem, it is not cost effective to build an Electronic Driver that rejects all ripple control frequencies given the small proportion of people affected, a cost that would have to ultimately be borne by all customers.

Cambios y devoluciones gratis

Envíos 24/48H.

Envíos gratis a partir de 49,90€